When I picked up the facial mask instruction manual and studied it, the more I looked at it, the more I felt familiar, until I finished reading it, I realized that the step of applying the facial mask is not the carbon fiber cloth strengthening reinforcement process?

With the scientific research spirit of "bold doubt and careful verification" of science students, I took the opportunity to talk to a female colleague:

Can you teach me to apply a facial mask?

When did you a big man start applying facial mask, hahahahahaha! ! !

You may not believe it. I find that the steps of applying a mask are the same as applying carbon fiber reinforcement...

Your "occupational disease" is hopeless. In this way, I will teach you the complete set of steps for applying facial mask.

OK, please tell me, teacher!

First of all, do a good job of cleansing before applying facial mask. For those who don’t apply facial mask all year round, you need to exfoliate

This is not right. When attaching carbon fiber cloth, the first step is to remove the stucco layer on the concrete surface of the component to be reinforced, smooth the surface, and then polish the edges and corners of the component section into rounded corners.

The next step is to clean the face, depending on the skin condition, some can apply a layer of toner first

This step is similar, we will first clean the concrete surface, keep it dry, and place the line according to the drawing.Apply carbon fiber primer on the concrete surface. For defects such as large holes, concave surfaces, and leaking ribs on the surface, repairing glue will be used to repair and level

Then, choose the facial mask that suits you. In addition to the functional choice, you also need to pay attention to the size. Don’t match the nose and eyes

Before we stick the carbon cloth, we will also cut the carbon fiber cloth according to the design size, and we will also weigh and configure the glue according to the specified ratio, mix and stir at low speed to impregnate the resin until the glue is uniform in color and no bubbles, and the preparation work is also very sufficient.

After choosing a facial mask, you have reached the most critical step. When applying the facial mask, first push it from the nose to the entire face, and then slowly smooth the facial mask to push out the air to ensure that it fits tightly

This is also a key step for sticking carbon cloth. After the primer on the surface of the concrete is dry, the dipping glue will be uniformly rolled.Then stick the carbon cloth on the concrete surface according to the position of the line.Then along the direction of the fabric fiber, use a special plastic scraper to smooth the surface of the pasted fiber cloth

Finally, wait for 15-20 minutes to remove the facial mask, clean the face, and then apply the usual skin care products.

Finally there is a difference!

Our carbon fiber cloth needs to be attached to it all the time, and then the carbon fiber dipping glue is applied twice to make the glue liquid fully infiltrate the fiber fabric and make the fabric layer evenly compacted without bubbles. After curing and curing, it is over!

Hahaha, this comparison really looks a lot like this

I'll just say it's like it. If a male colleague asks about applying a facial mask in the future, you can directly take out the construction video of carbon cloth reinforcement as a teaching material, so you can teach it once!I have prepared all the videos for you!